Heat- & Fire Detection


+ 43 1 706 43 000



Temperature Control Products From Fenwal

Electronic Controllers 

Fenwal electronic temperature controllers are built for "Easy-Use" and utilize thermocouple, RTD or thermistor sensors, and are versatile, economical solutions for applications requiring precise control.

The Series 59 is an exceptionally versatile and configurable microprocessor based ON/OFF control and is built for easy installation and operation. It's available for power supplies of either 24 VAC/VDC, or 120/208/240 VAC (field selectable). Setpoint values are entered via push-button switches to configure the controller.

The Series 58 ON/OFF control offers a choice of a relay or SSR driver outputs and an optional LCD meter for temperature indication. A local setpoint is adjustable from the front or rear of the board, and an optional potentiometer provides for remote setting.
Series 59   Datasheet 
Large 3-Digit LED Display
Thermocouple, RTD, or Thermistor Sensing
Versatile and Configurable with a Wide Range of Options

Microprocessor-based- no cumbersome menus
Large 3-digit LED display - permits easy viewing from a distance
RTD, Thermistor, Thermocouple or Solid State
Adjustable differential and setpoint offset values- more stable control and less frequent cycling
LED status light - indicates when unit is heating or cooling
Sensor failure detection - shuts down control
Conformal coating protection
Factory pre-set or field adjustable units available
Low cost alternative to DIN controllers

Membrane switch interface
On-board alarm
SSR driver or 5/15/30 amp relay output

Adjustable temperature range from -199°F to 999°F
Supply Voltage: 120/208/240 VAC, 24 VAC, 24 VDC
Output type: SPDT or solid state relay driver

Agency Approvals : UL, C UL
Series 58   Datasheet 
 Thermocouple or RTD Sensing
Optional Remote LCD Indication and/or Potentiometer
Sensor Inputs: Thermocouples type J, K, T or 100 ohm RTD, 1000 ohm RTD
Local setpoint with optional reverse mounting
Lead break protection
Snap track or standoff mounting

3-digit remote LCD display
Remote setpoint potentiometer

Adjustable temperature range from 0°F to 1000°F
Supply Voltage: 120/208/240 VAC, 24 VDC
Output: 2 Amp or 15 Amp SPDT, 20 Amp SPST, SSR Driver

Agency Approvals : UL


LICO Electronics GmbH
Klederinger Strasse 31
A-2320 Kledering/Wien
Vienna - Austria

Tel +43.1.706 43 000
Fax +43.1.706 41 31
email: h.miksch@lico.at
email: office@lico.at